house wrap
A membrane material installed over exterior sheathing (like OSB) to control water and air infiltration into the building envelope while allowing some vapor transmission
As defined in Mold and Rot on a BRAND NEW HOUSE - What went wrong?
Where it comes up · 1
Most important claims · 10 of 15Search all claims for “house wrap” →
- Modern construction codes create sealed wall cavities with insufficient air flow to dry trapped moisture, even when house wrap has high perm ratings, unlike 1930s houses with no insulation that had abundant air circulation through cavitiesMold and Rot on a BRAND NEW HOUSE - What went wrong?
- The corner with minimal overhang and fascia-to-fascia junction developed severe water damage: water ran down the facade, encountered the non-fully-adhered house wrap, and penetrated behind it, causing blackening and deterioration of OSB that in a six-month-old house resembles 20-year-old damageMold and Rot on a BRAND NEW HOUSE - What went wrong?
- The house wrap product used on this house is made by a third-party manufacturer and is woven material with micro-perforations, which gives it a perm rating but makes it inherently not waterproof—essentially a plastic saran wrap on the house with visible pin-dot holes when held to lightMold and Rot on a BRAND NEW HOUSE - What went wrong?
- Builders should never offer cheaper house wrap, cheaper waterproofing, or cheaper installation labor; they must spend the money correctly on this because waterproofing will be on the house for its entire lifespanMold and Rot on a BRAND NEW HOUSE - What went wrong?
- Capillary action pulls water through fastener penetrations and into house wrap materials when pressure is applied, which is why cap fasteners that break capillary action perform better than plain staplesMold and Rot on a BRAND NEW HOUSE - What went wrong?
- A house with a one-to-one-and-a-half foot overhang had no water problems on the OSB, even when covered with the inferior house wrap, because the large overhang protected the facade from water exposureMold and Rot on a BRAND NEW HOUSE - What went wrong?
- The problem with micro-perforated house wrap is that it is not inherently waterproof; the big brand white house wraps are woven materials without micro-perforations that are inherently waterproofMold and Rot on a BRAND NEW HOUSE - What went wrong?
- The builder correctly laced three-sided flashing around windows and cut the house wrap at a 45-degree angle, flapping it up and applying peel-and-stick to the OSB, but failed to install sill pans, which is a critical detailMold and Rot on a BRAND NEW HOUSE - What went wrong?
- Jordan created a testing apparatus using the actual house wrap from the house, stapled to OSB with a paper towel behind it, with two fastener conditions: a regular staple and a cap staple that breaks capillary actionMold and Rot on a BRAND NEW HOUSE - What went wrong?
- Water pressurized through a backpack sprayer immediately penetrated the house wrap without a staple, penetrated easily with a staple, but showed markedly reduced penetration with a cap staple, though still some water reached the OSB after a few seconds of water pressureMold and Rot on a BRAND NEW HOUSE - What went wrong?